$515.00
The quick shafts are used to connect to any number of other quick shafts in...
$2,360.00
This tool pack comes with everything you will need to go under any 16 foot...
$128.00
The impact cap slides into the female threaded end of all shafts (opposite the point...
$3,875.00
This tool pack comes with everything that you will need to go under any 21...
$524.00
The 5 ft. master shaft is usually the first shaft to go into the ground...
$88.00
This part is used to connect the Bullet Mole's impact cap to a jack hammer....
$110.00
The compression point is the first part to go through the ground and is attached...
$109.00
This is used to support the shafts and hold them up off of the ground...
$78.00
This part is used to insert a 3/4" or 1" Sch 40 pipe into the...
$38.00
The push cap is attached directly to the PVC pipe that is ready to be...
$100.00
Typically this part is not necessary but it can be very useful when going through...
$173.00
This point is actually 2-3/8" in diameter and will make a hole large enough to...
$128.00
The compression point is the first part to go through the ground and is attached...
$99.00
This part is used to insert a 1-1/2" Sch 40 pipe into the ground after...
$188.00
This part is used to insert a 2" Sch 40 pipe into the ground after...
$287.00
This particular point is the Largest point that we sell. It is actually 3" in diameter...
$238.00
This Pelican Pro Pack case keeps all of your Bullet Mole Components dry organized and...
$35.00
This pull connector is used to attach any 3/4" - 1" NPT(National Pipe Thread) Fitting...
$580.00
This kit includes 4- 49" long shafts and comes with a 1-3/4" compression point that...
$53.00
The push cap is attached directly to the PVC pipe that is ready to be...
$50.00
This is used to support the shafts and hold them up off of the ground...