The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed. The push point is connected to the front or leading end of the pipe and the push cap is inserted into the opposite end of the same pipe. Once in place, the push cap may be struck with a hammer to drive the pipe past the obstruction and on to the other side.
NOTE: This part is rarely used but in the case of pockets of gravel or roots pushing back into the hole, it can be difficult to slide the pipe in by hand with the push point. In which case the "Equalizer" here will blast the pipe past the obstruction every time.
The push cap is attached directly to the PVC pipe that is ready to be...
This part is made of a very tough American-made steel, which is heat treated and...